ORIGINAL & OTHER VINCENT PARTS

FIREFLY MOTOR COVER, original part, stamped aluminum - $60 "VINCENT" in raised letters. I made bronze belt buckles using the Firefly logo.

PR27 VINCENT REAR NUMBER PLATE - $100 From the 1980'S. Extra license plate mounting holes and a couple of cracks. Cracks are highlighted with the red lines. Never crashed or bent out of shape. Just a straight up weld repair on sheetmetal.

PR17 AMAL DUAL CHOKE LEVER, original, Vincent twins - $280, one only. Works OK. Later B's and C's. AMAL clip is an original part.

G78/G108 GEAR CHANGE ASSEMBLY, complete - $250 Series B Vincent Twin. Original parts, except for hex nuts and FT84/1.

FT3 CYLINDER HEAD BRACKET, original part - $90Series B for front and rear. Series C for rear.I purchased this with the idea of reproducing. Didn't happen.

FT220R and FT220L FRICTION PLATES, right and left, reproduction parts - $35 setStainless steel. New. Came with a mostly original Brampton I purchased.Original Friction plates were chrome plated steel. I make those.

G108/2 GEARCHANGE LEVER, reproduction part - $90, only one left.Aluminum. These have never been broken or welded.

T4/2 and F103 - Original Comet Inner Primary Chain Case with Pivot Bearing Spacer- $550 (my cost)Parts in good usable condition. I purchased these original Vincent parts with an idea to make the F103, I didn't.Current reproductions (Coventry Spares $832, VOC 626 pounds) have the F103 cast integrally with the Chain Case. A weak rationalization.

Complete Brampton Forks, original - $4795, same price as my forks.I had to replace the riser caps, fork links, and F55 with my chromoly steel parts. The supplied reproduction parts were poor.The 4 swaged fork tubes were replaced by Ray Danials of the UK. Fork is straight. Choice of chromed steel knobs or polished aluminum.